TPI GPO – Helper block

The TPI GPO helper block is a wrapper that simplifies the use of the GPO block with the all-in-one programmable inverter (TPI8032 22kW).

Simulink GPO helper block

Signal specification

• The GPO pin is set if the input is >0
• The sim output signal is used in simulation and documented in Simulation essentials with Simulink (PN135).

Parameters

• Device ID selects which TPI to address when used in a multi-device configuration.
• GPO bit selects one pin to control.
• Reset pin value to 0 in case of fault acts when a fault is detected, for instance when an analog inputs exceeds a configured limit value.
• Show simulation output port defines if the simulation output port is displayed or not.

PLECS GPO helper block

Signal specification

• The GPO pin is set if the input is >0
• The target output ports (only visible at the atomic subsystem level) is used in simulation and documented in Simulation essentials with PLECS (PN137).

Parameters

• Device ID selects which TPI to address when used in a multi-device configuration.
• GPO bit selects one pin to control.
• Optional reset can be set to Reset pin value to 0 in case of fault to act when a fault is detected, for instance when an analog inputs exceeds a configured limit value.
• Show simulation output port defines if the simulation output port is displayed or not.

C++ functions

There are no C++ helper functions for the TPI. Please refer to the generic GPO functions.